Metric Hex Tap Bolt, Class 10.9, Zinc Plated Steel, M10 x 1.50 x 120M
Diameter - Thread Pitch: M10-1.50
| Quantity | Unit price |
|---|---|
| 1 – 99 |
$1.57*
|
| 100 – 999 |
$1.40*
|
| 1000+ |
$1.27*
|
- Across Flats (Width): 17mm (Max 17.00mm - Min 16.73mm)
- Additional Sizing Info: FT = Full Thread, PT = Partial Thread
- Color: Silver
- Diameter: M10
- Drive Style: External Hex
- Head Type: Hex Head
- Thread Direction: Right Hand
- Thread Type: Coarse
- Finish: Zinc Plated
- Fit: 6g
- Grade: 10.9 (Grade 8 Metric Equivalent)
- Head Height: Max 6.58 - Min 6.22
- Head Height Basic: 6.4 mm
- Head Style: Hex
- Length: 120MM
- Material: Steel
- Product Type: Metric Hex Cap Screw
- System of Measurement: Metric
- Thread Direction: Right Hand
- Thread Pitch: 1.50 mm
- Thread Size: M10 x 1.5
- Thread Standard: UNC
- Thread Type: Coarse
- Tolerance (IFI): Actual measurements may vary slightly +/- depending on production run within IFI Tolerances
- Wrench Size: 17mm
|
This M10 x 1.5mm hex tap bolt is manufactured from Class 10.9 high-strength steel with a zinc plated finish for reliable corrosion resistance in indoor and sheltered outdoor applications. The partial thread design leaves an unthreaded shank section below the hex head, reducing stress concentration at the bolt-to-joint interface and providing superior shear strength compared to fully threaded alternatives. Class 10.9 steel delivers approximately 1,040 MPa tensile strength, making these fasteners suitable for heavy-duty structural connections, machinery assembly, and high-load applications where standard Class 8.8 bolts are insufficient. The zinc plating adds a protective barrier against moisture and mild environmental exposure while maintaining RoHS compliance.
A Hex Bolt is measured as: Diameter - Thread Pitch x Length from Under Head
FT = Full Thread
PT = Partial Thread