Fender Washers, Hot Dipped Galvanized Steel, #10 x 1-1/4" (.203 ID x 1-1/4 OD x .040 Thick)
Hot Dipped Galvanized Steel Large OD Fender Washers
- Prevent pull-through
- Allow for distribution of weight over greater area than with normal washers
- Can be used where rust has made a hole larger
- Used on materials that are softer such as sheet metal
- Hot dip galvanized fender washers to be used with HDG hardware
- Actual measurements may vary slightly +/- depending on production run
Fender Washer Specifications
| Flat Washer Sizes | Inner Diameter (ID) | Outer Diameter (OD) | Washer Thickness |
| #10 x 1" | 0.203" | 1" | 0.040" |
| #10 x 1-1/4" | 0.203" | 1-1/4" | 0.040" |
| 1/4" x 11/16" | 0.281" | 11/16" | 0.050" |
| 1/4" x 1" | 0.281" | 1" | 0.050" |
| 1/4" x 1-1/4" | 0.281" | 1-1/4" | 0.050" |
| 1/4" x 1-1/2" | 0.281" | 1-1/2" | 0.050" |
| 1/4" x 2" | 0.281" | 2" | 0.062" |
| 5/16" x 1" | 0.343" | 1" | 0.050" |
| 5/16" x 1-1/4" | 0.343" | 1-1/4" | 0.050" |
| 5/16" x 1-1/2" | 0.343" | 1-1/2" | 0.062" |
| 5/16" x 2" | 0.343" | 2" | 0.062" |
| 3/8" x 1" | 0.406" | 1" | 0.050" |
| 3/8" x 1-1/4" | 0.406" | 1-1/4" | 0.050" |
| 3/8" x 1-1/2" | 0.406" | 1-1/2" | 0.050" |
| 3/8" x 2" | 0.406" | 2" | 0.062" |
| 1/2" x 1-1/2" | 0.531" | 1-1/2" | 0.062" |
| 1/2" x 1-3/8" | 0.531" | 1-3/8" | 0.062" |
| 1/2" x 2" | 0.531" | 2" | 0.062" |
Product number:
FWHDG110114