The epoxy stoppers, or also know as retaining caps make overhead and horizontal anchor installation easier by keeping the adhesive in the hole until cured. The stopper helps to center the epoxy applicator in the center of the drilled hole. This ensures accurate application and reduces the possibility of air pockets or voids when installing adhesives into drilled holes.
The stopper provides temporary support but is not meant to bear the weight of the anchor in overhead positions. You should remove the stopper before inserting the anchor rod/rebar once the adhesive has cured sufficiently.
These epoxy stoppers are used with adhesive anchoring systems. You can install them on ceilings, horizontal surfaces, and inclined surfaces. The surfaces may consist of concrete, masonry, or stone.
They are essential accessories. Like a piston plug, they prevent messy adhesive overflow and achieve consistently positioned anchors with epoxy stoppers designed for overhead use.
Available Sizes:
- 18MM Epoxy Stopper for Overhead Use
- 22MM Epoxy Stopper for Overhead Use
- 30MM Epoxy Stopper for Overhead Use
Ensure that your epoxy anchoring installations are clean and precise. Use our Epoxy Stoppers, available in sizes that fit common hole diameters. Nylon material is strong and easy to remove when the adhesive anchor is ready for the threaded rod or rebar.
