Hurricane Kit Wood Screws, Flat Washers & Driver - 41 Pcs For Wood Frames
Hurricane Protection Kit for Wood Frame Structures
- Kit Contents:
- #14 x 3" 18-8 Stainless Steel Philips Drive Wood Screws - 20 pieces
- 1/4" Stainless Flat Washers - 20 pieces
- #3 Phillips Power Bit - 1 piece
- 1/4"-20 Thread Size / Diameter
- Corrosion Resistant 18-8 Stainless Steel Hardware
- Phillips Drive Style and included bit for convenience and easy installation
- Large washers to prevent pull-through
- Fast, secure installation with standard tools
- Each kit covers one window or door.
- For Wood Framed Windows & Doors Only — Not for Brick or Concrete
Instructions:
- Measure and pre-cut plywood panels to fit windows.
- Position panel over window and mark screw hole locations 6-12" apart.
- Pre-drill pilot holes if needed.
- Insert screws with washers and tighten until snug.
Product Disclaimer
These hurricane hardware kits are assembled for customer convenience to assist in the preparation and protection of residential or commercial properties during hurricanes, nor’easters, severe storms, and adverse weather conditions. While the components have been selected to help secure plywood panels and reduce the risk of damage, weather conditions such as wind speed, flying debris, and storm severity can vary greatly and may exceed the protective capabilities of this kit.
Use of this product does not guarantee the prevention of property damage or personal injury. Always follow local building codes, consult with a licensed contractor when in doubt, and stay informed through official weather advisories and emergency management recommendations.
Albany County Fasteners assumes no liability for damages or losses resulting from storm events or use or misuse of this product.