3/4" Shear Connector Weld Studs Steel

3/4" Headed Shear Connector Welding Studs

Headed Weld Studs in Plain Steel with a 3/4" Diameter

Headed Shear Connector Weld Studs interconnect concrete slabs to load bearing beams where strong shear resistance is needed most. Each Stud comes with a Ferrule ceramic cap to reduce spatter and give the weld a finished look.

Weld Studs are installed using a drawn arc stud welding gun to create a permanent, high strength bond with an incredibly fast installation time while still being a strong, one-sided weld.

Welding Studs in this selection are unthreaded and each stud comes with a matching ferrule for installations on flat surfaces. All 3/4" Weld Studs in this selection have a Head Diameter of approx. 1-1/4" and Head Thickness of approx. 3/8" and are made of plain steel.

Weld Studs are Commonly Used In:

  • Buildings
  • Bridges
  • Power Distribution Equipment
  • Food Service
  • Vehicles
  • Ship Building
  • Military Applications
  • Embed Plates

Weld studs are listed as Diameter x Length (Including Head)

PLEASE NOTE: Lengths listed are BEFORE the weld. 3/4" Diameter Studs will be approx. 3/16" shorter after welding.

Additional Ferrule Cap Styles such as Inside angle, Outside angle, and Vertical are available upon request. Please call our office at 866-573-0445 for more details.

You May Also Like:

Welding Safety Equipment
Welding Equipment
Select Products Below
See Product Specifications
NA = "Not Sold In Single Quantity"

Select Package Quantity
Loading ...

Product Specifications
A29/A108, 1010-1020
20% (in 2 inches)
Head Diameter
Head Height
Low Carbon Steel
Product Type
Headed Weld Studs
System of Measurement (Unit)
Tensile PSI
65,000 PSI min
Thread Direction
Right Hand
Tolerance (IFI)
Actual measurements may vary slightly +/- depending on production run within IFI Tolerances
Yield PSI
51,000 PSI min.