Cotter Pins, Brass, 1/4" x 1-1/4"
Used With Castle Or Slotted Hex Nuts
| Quantity | Unit price |
|---|---|
| To 99 |
$1.21*
|
| To 999 |
$0.81*
|
| From 1000 |
$0.74*
|
- Color: Yellow
- Color May Vary: Yes
- Corrosion Resistant: Yes
- Diameter: 1/4"
- Length: 1-1/4"
- Material: Brass
- Product Type: Cotter Pins
- System of Measurement: Inch
- Tolerance (IFI): Actual measurements may vary slightly +/- depending on production run within IFI Tolerances
- Extended Prong
- Square Cut
- Should not be reused
- Used to lock castle or hex slotted nuts in place
1/4" Brass cotter pins are inserted into a hole that has been drilled through a bolt after the nut has been installed. The cotter, or split pin is then deformed with a pair of pliers to prevent it from comming back out of the hole. This in turn prevents the nut from being able to vibrate loose off of the threading.
Cotter pins are mostly used with:
Product number:
1060-198-0002