#10-24 Brass Knurled Head Thumb Screws
Diameter - Thread Pitch: #10-24
- Knurled head intended to be driven by fingers
- ASME Standards specific
- A machine screw is commonly identified by its small size
- Aesthetically pleasing and typically used for ornamental products
- The more zinc in a screw the lighter it will tend to be
- Brass is corrosive resistant but very soft material
- Commonly used for:
- Firearms
- Weather Stripping
- Pipes
#10-24 Knurled head thumb machine screws are available in corrosion resistant brass.
NOTE: Color and sheen may vary
See Product Specifications
NA = "Not Sold In Single Quantity"
Select Package Quantity
Loading ...
Product Specifications
ANSI
B18.6.3
Color
Yellow
Color May Vary
Color and sheen may vary
Corrosion Resistant
Yes
Drive Style
Thumb
Elongation
10% - 25%
Hardness
40-75 Rockwell B
Head Diameter
0.440" (Just Over 7/16")
Head Style
Thumb
Material
Brass
Overall Head Height
3/8" (From Bottom to Top of Head)
Product Type
Knurled Head Thumb Screws
System of Measurement (Unit)
Inch
Tensile PSI
50,000 - 65,000 PSI
Thread Diameter
(#10) Max 0.1890 - Min 0.1818
Thread Direction
Right Hand
Thread Pitch (Count)
24 Per Inch
Thread Standard
UNC
Thread Type
Coarse
Tolerance (IFI)
Actual measurements may vary slightly +/- depending on production run within IFI Tolerances
Yield PSI
30,000 - 50,000 PSI
