Installing Tapcon Masonry Screws

How To Install Masonry Screwsinstalling masonry screws

Masonry screws are used to fasten materials to different masonry materials (usually concrete). Tapcon is a brand that has become a generic term for these screws over the years, often referred to as tapcon screws.

Tapcon screws can be identified by their blue coloration. Most of them are fully threaded but some longer screws will have a smooth shoulder. This shoulder is designed to disperse the heat built up by the screw. If the shoulder was absent the screw would heat up exponentially and expand it the hole. This expansion plus the heat of the screw can compromise its integrity causing the screw to snap.

Now that we know a bit about masonry screw lets begin installing one.

Getting Started

What you will need:

  • Concrete Drill Bit
  • Drill
  • Painters Tape
  • Tapcon Screws
  • Various Driver Bits depending on which head style you choose
  • Safety Gear!installing tapcon screws

Step 1

The first thing we need to do is take the screw we are going to install and mark the end of the drill bit with painters tape. We do not want to drill an excessive hole in the concrete it only needs to be long enough.

Once we have our drill taped, its time for the most important part of our drilling into concreteinstallation. Putting on our safety gloves and glasses to make sure we protect ourselves.

Step 2

With our safety gear on and drill in gloved hand we can begin drilling our hole into the concrete. Even short concrete screws will hold very well in concrete. These masonry screws cut their own threads and will only need to be installed a little over an inch to have some true holding power. Once you reach the desired depth marked by the tape, you may remove the drill and carefully wipe any extra debris away from the hole.

Step 3

screwing in tapcon masonry screws

This is the home stretch for installing a concrete screw. Find the appropriate bit driver. We decided to use the hex head slotted Tapcon screws due to their popularity. Simply drill the screw into the hole until the head reaches the surface of the concrete and you are done!


finished tapcon screw install


Looking For More Blogs Like This One?

Sign up to get new blogs sent directly to your inbox!

By submitting this form, you are consenting to receive marketing emails from: RAW PRODUCTS CORP, 100 Newfield Ave., Edison, NJ, 08837, You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact

Leave a Reply

Your email address will not be published. Required fields are marked *