3/4" x 8-3/16" Shear Connector Weld Studs, Steel
Headed Weld Studs in Plain Steel with a 3/4" Diameter
| Quantity | Unit price |
|---|---|
| 1 – 99 |
$6.18*
|
| 100 – 999 |
$6.06*
|
| 1000+ |
$6.03*
|
- ASTM: A29/A108, 1010-1020
- Color: Black
- Corrosion Resistant: Yes
- Elongation: 20% (in 2 inches)
- Thread Direction: Right Hand
- Finish: Plain
- Fit: 2A
- Head Height: ~3/8"
- Head Diameter: ~1-1/4"
- Head Style: Flat Disk
- Length: 8-3/16"
- Material: Carbon Steel
- Product Type: Masonry Anchor
- System of Measurement: Inch
- Tensile PSI: 65,000 PSI min
- Thread Direction: Right Hand
- Tolerance (IFI): Actual measurements may vary slightly +/- depending on production run within IFI Tolerances
- Yield PSI: 51,000 PSI min.
Headed Shear Connector Weld Studs interconnect concrete slabs to load bearing beams where strong shear resistance is needed most. Each Stud comes with a Ferrule ceramic cap to reduce spatter and give the weld a finished look.
Weld Studs are installed using a drawn arc stud welding gun to create a permanent, high strength bond with an incredibly fast installation time while still being a strong, one-sided weld.
Welding Studs in this selection are unthreaded and each stud comes with a matching ferrule for installations on flat surfaces. All 3/4" Weld Studs in this selection have a Head Diameter of approx. 1-1/4" and Head Thickness of approx. 3/8" and are made of plain steel.
Weld Studs are Commonly Used In:
- Buildings
- Bridges
- Power Distribution Equipment
- Food Service
- Vehicles
- Ship Building
- Military Applications
- Embed Plates
Weld studs are listed as Diameter x Length (Including Head)
PLEASE NOTE: Lengths listed are BEFORE the weld. 3/4" Diameter Studs will be approx. 3/16" shorter after welding.
Additional Ferrule Cap Styles such as Inside angle, Outside angle, and Vertical are available upon request. Please call our office at 866-573-0445 for more details.
You May Also Like:
| Welding Safety Equipment |
|