Nylon Lock Nuts 304 Stainless Steel

Stainless Steel Nylon Insert Hex Lock Nuts

Lock Nuts with a Nylon Insert in Corrosion Resistant 304 Stainless Steel

  • Hexagonal shape
  • Nylon material creates pressure against the fastener
  • Forces the bottom threads of the fastener against the top threads of the bolt
  • Creates a better hold
  • Locks the nut into place so it will not vibrate loose
  • Retain locking ability up to 250 °F (121 °C)
  • Also referred to as Nylon Lock Nuts or Nyloc Nuts

To prevent or stop galling (also known as seizing or locking-up) on stainless steel fasteners, we recommend using an anti-seize thread lubricant from our line of
MRO Solutions

Stainless Steel fasteners rubbing against each other (during installation) may cause a reaction known as Galling. The chance of galling increases significantly when a nylon insert is added to the nut. To limit the extra friction created by the nylon insert, Waxed Nylon Insert Lock Nuts are also available.

*Even when using Waxed Nylon Insert Lock Nuts, we still recommend using an MRO Anti-Seize Solution to further deter thread galling during any stainless steel fastener installation.

Nylon Insert
Lock Nut Size
Width Across Flats Height / Thickness
#4 0.251" 0.153"
#6 0.313" 0.188"
#8 0.345" 0.239"
#10 0.376" 0.249"
#12 0.439" 0.328"
1/4" 0.439" 0.328"
5/16" 0.502" 0.359"
3/8" 0.563" 0.468"
7/16" 0.627" 0.468"
1/2" 0.752" 0.609"
0.877" 0.656"
5/8" 0.940" 0.765"
3/4" 1.064" 0.890"
7/8" 1.252" 0.999"
1" 1.44" 1.078"
Select Products Below
See Product Specifications
Select Package Quantity
Loading ...
Product Specifications
Corrosion Resistant
Drive Style
External Hex
Stainless Steel
Product Type
Nylon Insert Lock Nut
System of Measurement (Unit)
Thread Direction
Right Hand
Tolerance (IFI)
Actual measurements may vary slightly +/- depending on production run within IFI Tolerances