Square Washers
What are Square Washers?
Square washers are flat washers with a square outside shape and a centered hole. The flat sides provide more edge contact in channels and timber, and the larger bearing area helps spread load and reduce pull-through on softer or irregular materials.
What are square washers used for?
- Spreading clamp force on wood framing, strut channel, and plate steel
- Reducing pull-through on oversized or slotted holes
- Keeping hardware from spinning in channels where flat sides register against edges
- Providing a larger footprint than standard round flat washers
Square washer vs flat and fender washer what is the difference?
A standard flat washer is round with a smaller outside diameter and is best where clearance is tight. A fender washer is round with an extra large outside diameter for maximum coverage. A square washer offers a broad footprint plus flat sides that seat well in channels and against wood grain for added stability.
When should I use beveled square washers?
Beveled square washers are used under nuts and bolt heads on sloped or tapered flanges, such as I beam flanges, so the bearing surface sits level. The bevel compensates for the angle, improving seating and preload.
What size square washer do I need? inch and metric
- Match the nominal washer size to your bolt or rod, for example 1/2 in or M12
- Confirm the inner diameter clears the shank without excess play
- Select the outside dimensions to fully cover the hole with margin
- Choose thickness based on load and the stiffness you need in wood or structural work
- Available in common inch and metric sizes to pair with US and metric fasteners
Materials and finishes
304 and 316 stainless steel
Corrosion resistant with a clean appearance. Use 316 for marine or harsh chemical exposure, 304 for general service.
Hot dip galvanized steel
Thick zinc coating suited to outdoor and structural applications. Pair with galvanized bolts and nuts.
Malleable iron and plain carbon steel
Durable choices for heavy plate and timber connections. Finish selection should match the environment.
Installation tips
- Seat the flat sides parallel to channel edges or with grain direction in wood for stability
- Use beveled patterns on angled flanges so the nut or bolt head bears on a level surface
- Tighten to the fastener’s recommended torque and re-check after initial set in wood
- Keep materials compatible in wet areas to limit galvanic corrosion
Applications
- Timber framing, sill plates, and anchor bolt connections
- Strut channel systems and base plates
- Outdoor structural hardware with galvanized fasteners
- Equipment mounting where wide bearing area is needed
FAQs about Square Washers
The bevel corrects for sloped or tapered flanges so the nut or bolt head bears on a level surface and preload is more consistent.
Match the nominal size to the bolt, verify the inner diameter fits the shank, and select outside dimensions and thickness that fully cover the hole and resist crushing.
Use 304 or 316 stainless for corrosion resistance and a clean finish. Use hot dip galvanized for outdoor structural work and pair with galvanized hardware.
Yes, the broad bearing area helps spread load on wood fibers and the flat sides resist rotation, especially under anchor nuts and through bolts.
They help with load spread and seating but do not lock by themselves. Use proper torque and add a locking method if vibration is present.
Plate washers are typically larger and thicker for structural or timber framing loads, while standard square washers are thinner and used in lighter assemblies.
Yes. Choose the matching metric size, for example M10 or M12, and confirm the inner diameter and thickness meet your application needs.
Align a flat side against the channel wall so the washer resists rotation and covers the slot evenly.
Use clean, flat bearing surfaces and tighten gradually. Select compatible finishes, such as galvanized with galvanized, to maintain protection.