Joist Hangers are framing connectors attached to the ends of wood or timber joists to the ledger board. They are typically used to help form the floor on decking applications. Joist Hangers wrap around three sides of a joist forming the parallel pattern often seen that make up deck floors, prior to being covered. These joist hangers allow installation of joists at 40-50 degree angles (skews) to ease installation of I-joists.
In decking applications, the height of a joist hanger should match the depth of the joist being used. The number of holes in a given joist hanger dictate the amount of nails expected to be used to make a secure connection.
All Decking Joist Hanger Anchors in this selection are made of 316 Stainless Steel for superior corrosion resistance. 316 Stainless Steel is well suited for applications in severe, harsh, or marine environments. Proudly made in the USA.
Skewed Joist Hangers are available in single sizes (for singular, standard sized joists) and either 45 Degrees Right or Left variants.
It is not recommended to mix metals during application. For example, a stainless steel joist hanger should be used with the same grade of stainless steel nails. In addition, only nails should be used when installing joist hangers.